Saftronics HPVFE - Basic Program Group Parameters; Motor Nameplate Data Setup; Frequency Limit Setup

Basic Program Group
Sailer Manual HPVFE
39
P101 [Motor NP Volts] Related Parameter(s): d004, A453
Stop drive before changing this parameter.
Set to the motor nameplate rated voltage.
Values Default Based on Drive Rating
Min/Max: 20/Drive Rated Voltage
Display: 1 VAC
P102 [Motor NP Hertz] Related Parameter(s): A453, A444
Stop drive before changing this parameter.
Set to the motor nameplate rated frequency.
Values
Default 60 Hz
Min/Max: 10/400 Hz
Display: 1 Hz
P103
[Motor OL Current] Related Parameter(s): P111, t221, A441, A444, A448, A437
Set to the maximum allowable motor current.
The drive will fault on an F7 Motor Overload if the value of this parameter is exceeded by 150% for 60 seconds or 200% for 3 seconds.
Values Default Based on Drive Rating
Min/Max:
0.0/(Drive Rated Amps ⋅ 2)
Display: 0.1 Amps
P104 [Minimum Freq] Related Parameter(s): d001, d002, d013, P105, t211, t213, A438
Sets the lowest frequency the drive will output continuously.
Values Default 0.0 Hz
Min/Max: 0.0/400.0 Hz
Display: 0.1 Hz
P105 [Maximum Freq] Related Parameter(s): d001, d002, d013, P104, A404, t212,
t214, A438
Stop drive before changing this parameter.
Sets the highest frequency the drive will output.
Values Default 60 Hz
Min/Max: 0/400 Hz
Display: 1 Hz