Sagem D86C - Device Configuration Options

25
-Press Menu button.
- Press Navigation (up/down/left/right) button to select the Settings.
-Press OK.
- Press Up or Down button to select one of the below item:
Handset Settings
Base Settings
Handset Settings
-Press OK.
- Press Up or Down button to select one of the below item:
Auto answer
Register HS
Economy mode
Handset Name
Language
Default HS
Room Monitor
Auto answer
- Press On/Off button to set Auto answer on/off (if set to on, during an incoming call you can
take the handset from base unit to directly answer the call).
Register a new handset to a base
-Press OK to enter PIN (Personal Identification number).
- Enter PIN number 0000(default: 0000).
-Press OK to register handset to Base.
Note: if you want to register handset to base, you should be press and hold base Page button
until you hear beep tone.
Note: if you do not want register handset to base you can press Back button to go back
standby model.
- After registration is completed, the handsets will suggest the available Handset number
(from 1-5). You can choose the number you want to associate by pressing the corresponding
digit key. (press 1 key to choose Handset number 1).
SETTINGS
LU 252976139A D86C EN.book Page 25 Vendredi, 3. août 2007 9:56 09