Sako SKI600 - Page 45

039
4.1 Function Code
F4 Group - Speed Loop, Torque and Flux Control Parameters
Function
Code
Name Set Range
Minimum
Unit
Factory
Default
Modi󽗉cation
F4.13 Tarque set by keypad
-200.0% ～ 200.0%*rated
current of motor
0.1% 0.0% ○
F4.14
Speed limit channel
1 of torque control
mode (forward)
0: keypad set 1
1: AI1
2: AI2
1 0 ○
F4.15
speed limit channel
1 of torque control
mode (reverse)
0: keypad set 2
1: AI1
2: AI2
1 0 ○
F4.16 Keypad limit speed 1
0.0 ～ 100.0%*【F0.15】
maximum freq.
0.1% 100.0% ○
F4.17 Keypad limit speed 2
0.0 ～ 100.0%*【F0.15】
maximum freq.
0.1% 100.0% ○
F4.18 Torque rise time 0.0 ～ 10.0s 0.1s 0.1 ○
F4.19 Torque decline time 0.0 ～ 10.0s 0.1s 0.1 ○
F4.20
Electromotion
torque limit of vector
mode
G type: 0.0％～ 200.0％ *rated
current of motor 180.0%
P type: 0.0％～ 200.0％ *rated
current of motor 120.0%
0.1%
Depending
on model
○
F4.21
braking torque limit
of vector mode
G type: 0.0％～ 200.0％ *rated
current of motor 180.0%
P type: 0.0％～ 200.0％ *rated
current of motor 120.0%
0.1%
Depending
on model
○