30 | EN SMARTY v2023.2
7. CONTROL
7.1. DEVICE CONTROL
Ventilation unit equipped with miniMCB control board can be controlled with remote controller, WEB interface or mobile app via MB-GATEWAY
and BMS (Building Management System). More information provided in the table below.
With MB-GATEWAY Remote control panels BMS direct connection Wireless communication
Web interface
SALDA AIR mobile application
BMS over Modbus TCP/IP
BMS over BACnet TCP/IP
Stouch
ST-SA-Control
Modbus RTU (RS485) MB-GATEWAY + WIFI router
Ventilation unit equipped with S300 control board can be controlled with remote control panel, mobile app via WIFI and BMS (Building Manage-
ment System). More information provided in the table below.
With MB-GATEWAY Remote control panels BMS direct connection Wireless communication
BMS over Modbus TCP/IP POS8.4420
POS8.4440
Modbus RTU (485)
BACnet IP
WIFI stick + mobile app
7.2. DEVICE FUNCTIONS
All miniMCB control boards are run by the same software with all functions included. Full function list and description you can nd on the MCB/
miniMCB technical manual. However, operation and control of the device depends on the following factors:
1. Selected control interface (remote control panel, MB-GATEWAY, etc.). The selected interface aects access to the information and settings,
however, it does not aect the logic of control. Full access to the information and settings is available on ST-SA-Control, MB-GATEWAY WEB
application and SALDA AIR mobile application.
2. Unit conguration (internal/external components, sensors and control board settings).
Smarty S300 units have integrated ecient microprocessor-based Siemens S300 controller (full controller’s function list and description you can
nd on the Siemens S300 technical manual). All unit‘s active components are controlled by Siemens controller. It has a lot of functions that can
eciently operate air handling unit. Users have access to the controller conguration where the control settings can be changed or new con-
trollable devices can be added to the air control system. Users can also connect to the controller and monitor unit‘s status or change preferred
environment settings.
Operation and control of the device depends on the following factors:
1. Selected control interface. The selected interface aects access to the information and settings, however, it does not aect the logic of the
control. Remote controller have access of only basic user functions. Full access to the unit’s conguration settings is available on ABT Go mobile
application for installer and service users.
2. Unit conguration (internal/external components, sensors and controller settings).
For unit control instructions, refer to the operation manual of the existing control device.
To Next Page
Loading...
Need help?
General
