Sam4s ELLIX35III - Page 11

CHAPTER 2
11
3. The self-test prints the current printer status, which provides the
control firmware version and the printer setting.
4. The printer will be paused temporarily after printing the current printer
status. (The 'No Paper' LED or the LCD light blinks) The GIANT Series
printer will automatically execute 'Step 5' after 2 seconds.
5. Press the FEED button to continue printing. The printer prints a pattern
using the built-in character set.
6. The self-test automatically ends and cuts the paper after printing the
following.
** Completed **
7. The printer is ready to receive data as soon as it completes the self-test.
8. You can find interface type of SAM4S printer from the self-test as follow.
Interface list
· USB-I INTERFACE for
‘SERIAL / V-COM CONNECTION’
· USB-II INTERFACE for
‘USB CONNECTION’
· PARALLEL INTERFACE for
‘PARALLEL CONNECTION’
· Ethernet-II INTERFACE for
‘ETHERNET CONNECTION’
· WIRELESS LAN (WLAN) INTERFACE for
‘ETHERNET CONNECTION’
· SERIAL (RS-232C) INTERFACE - 25 pin
for ‘SERIAL / VCOM CONNECTION’
· SERIAL/WIRELESS INTERFACE - 9 pin
for ‘SERIAL / VCOM CONNECTION’
2.1. Verify interface type of SAM4S printer