Sam4s ELLIX35III - Overview

5
CHAPTER 1
1
1.1. Overview
This document contains how to install/uninstall a SAM4S printer with an
interface and contains how to configure a SAM4S printer.
See below on installing SAM4S printer:
1. Verify interface of SAM4S printer (p.10)
2. Install proper SAM4S printer driver
1) In case of a serial printer. (p.12)
2) In case of a parallel printer. (p.14)
3) In case of an USB printer. (p.16)
4) In case of an USB to Serial printer (Windows 7). (p.19)
5) In case of an USB to Serial printer (Windows 10). (p.21)
6) In case of an Ethernet printer. (p.23)
3. Make sure installed printer is properly works (p.25)
4. Refer to uninstall a printer (p.27)
The SAM4S printer driver installer (V3.0.0 or above) supports following models:
1. ELLIX30/30III/40 (32bit / 64bit)
2. ELLIX35/35III/45 (32bit / 64bit)
3. ELLIX32/42/37 (32bit / 64bit)
4. GIANT-100 (32bit / 64bit)
5. GIANT-150 (32bit / 64bit)
6. GIANT PRO (32bit / 64bit)
The SAM4S printer driver installer supports English and Korean.
>>
Refer to 1.2. Operating Environment
Getting Started
CHAPTER