Sam4s ER-180U - Program 80 - Function Key Descriptor

ER-180U Program Mode Programming
•
61
Program 300 - PLU Descriptor Programming
1. Move to the PGM-Mode.
2. To begin the program, enter 3 0 0, press the SBTL key.
0
SBTL
0
3
3. Select the PLU you wish to program in one of the following ways:
• Enter up to 500 of the PLU and press the PLU key, or
PLU
Enter the PLU#,
up to 500
4. Enter 12 three character codes.Refer to the descriptor code chart.
X/TIME
065 080 080
076 069
5. To program additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
CASH