Samson 3510 Series - Technical Data

EB 8091 EN 3-5
Design and principle of operation
3.4 Technical data
The nameplates on the valve and actuator
provide information on the control valve ver-
sion. See the 'Markings on the device' sec-
tion.
More information is available in Data Sheet
uT8091.
Compliance
The Type3510 Valve bears both the CE and
EAC marks of conformity.
Temperature range
Depending on the version, the control valve
is designed for a temperature range from
–10 to +220°C. The use of an insulating
section or bellows seal can extend the tem-
perature range down to –196 and up to
+450°C (higher temperatures on request)
depending on the properties of the materials
used.
Leakage class
Depending on the version, the following
leakage class according to IEC60534 ap-
plies:
− Leakage class IV with metal seal
− Leakage class V for high-performance
metal seal
Noise emissions
SAMSON is unable to make general state-
ments about noise emissions. The noise emis-
sions depend on the valve version, plant fa-
cilities and process medium.
Note