EasyManua.ls Logo

Samson 3510 Series - 9 Servicing

Samson 3510 Series
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EB 8091 EN 9-1
Servicing
9 Servicing
The work described in this section is only to
be performed by personnel appropriately
qualied to carry out such tasks.
The following documents are also necessary
for servicing the valve:
Mounting and operating instructions for
mounted actuator, e.g. uEB8310-1 for
Type3271 and Type3277 Pneumatic
Actuator with 120cm² actuator area
uAB0100 for tools, tightening torques
and lubricant
Risk of bursting due to incorrect opening of
pressurized equipment or components.
Valves and pipelines are pressure equipment
that may burst when handled incorrectly.
Flying projectile fragments or the release of
process medium under pressure can cause
serious injury or even death.
Before working on the control valve:
Î Depressurize all plant sections affected
and the valve (including the actuator).
Release any stored energy.
Î Drain the process medium from all the
plant sections concerned as well as the
valve.
Risk of burn injuries due to hot or cold
components and pipeline.
Valve components and the pipeline may
become very hot or cold. Risk of burn
injuries.
Î Allow components and pipelines to cool
down or warm up to reach ambient tem-
perature.
Î Wear protective clothing and safety
gloves.
Risk of personal injury due to pressurized
components and process medium being dis-
charged.
Î Do not loosen the screw of the test con-
nection while the valve is pressurized.
Risk of hearing loss or deafness due to loud
noise.
Noise emission (e.g. cavitation or ashing)
may occur during operation caused by the
process medium and the operating
conditions. Additionally, a loud noise may
briey occur through the sudden venting of
the pneumatic actuator or pneumatic valve
accessories not tted with noise-reducing
ttings. Both can damage hearing.
Î Wear hearing protection when working
near the valve.
Crush hazard arising from actuator and
plug stem moving.
Î Do not insert hands or nger into the
yoke while the air supply is connected to
the actuator.
DANGER
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!

Table of Contents

Related product manuals