Samson 3510 Series - Removing the Valve from the Pipeline; Removing the Actuator from the Valve

11-2 EB 8091 EN
Removal
11.1 Removing the valve from
the pipeline
a) Version with female thread
or anges
1. Support the valve to hold it in place
when separated from the pipeline (see
the 'Shipment and on-site transport' sec-
tion).
2. Unfasten the valve or unbolt the ange
joint.
3. Remove the valve from the pipeline (see
the 'Shipment and on-site transport' sec-
tion).
b) Version with welding ends
1. Support the valve to hold it in place
when separated from the pipeline (see
the 'Shipment and on-site transport' sec-
tion).
2. Cut the pipeline in front of the weld
seam.
3. Remove the valve from the pipeline (see
the 'Shipment and on-site transport' sec-
tion).
11.2 Removing the actuator
from the valve
See associated actuator documentation.