EB 8091 EN 9-15
Servicing
19. Place the insulating section (28) together
with the plug (2.1) and plug stem exten-
sion (22) onto the body. Use a suitable
tool to screw it into the body (1). Ob-
serve tightening torques.
20. Push the anti-rotation xture (24.1, with
'insulating section' inscribed on it) from
the top over the insulating section (28)
and x it in place with the llister head
screw (6).
21. Push the bottom section of the top an-
ti-rotation xture (24.2, without inscrip-
tion) with its bent end facing downward
onto the insulating section (28).
22. Place the washer (27) on the insulating
section (28).
23. Apply a suitable lubricant to the thread
of the intermediate piece (4).
24. Carefully place the intermediate piece (4)
over the plug stem extension (22) onto
the insulating section (28). Use a suitable
tool to screw it in. Observe tightening
torques.
It must be possible to turn the washer (27)
easily after the intermediate piece is fastened
tight. It must not be clamped down.
25. Push the top section of the top anti-rota-
tion xture (24.2, with 'plug, seat' etc.
inscribed on it) with the bent end facing
upward over the intermediate piece (4).
26. Insert the llister head screw (23) through
both parts of the anti-rotation xture
(24.2). Push the washer (25) from below
onto the screw and x in place with the
hex nut (26).
27. Place the yoke (13) onto the intermediate
piece (4) and secure with slotted nut
(11). Observe tightening torques.
Note
To Next Page
Loading...
