EasyManua.ls Logo

Samson 3767 - Servicing

Samson 3767
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EB 8355-2 EN 9-1
Servicing
9 Servicing
The work described in this section is only to
be performed by personnel appropriately
qualiedtocarryoutsuchtasks.
Risk of fatal injury due to the ignition of an
explosive atmosphere.
Î Observe EN60079-14 (VDE0165,
Part1) for work on the positioner in haz-
ardous areas.
Î Work in hazardous areas must only be
performed by personnel who has under-
gone special training or instructions or
who is authorized to work on explo-
sion-protected devices in hazardous ar-
eas.
Intrinsic safety rendered ineffective in in-
trinsically safe devices.
Î Only connect intrinsically safe devices in-
tended for use in intrinsically safe circuits
to certied intrinsically safe input-con-
nected units.
Î Do not place intrinsically safe devices
back into operation that were connected
to intrinsically safe input-connected units
without certication.
Î Do not exceed the maximum permissible
electric values specied in the EC type
examination certicates when intercon-
necting intrinsically safe electrical equip-
ment (U
i
or U
0
, l
i
or I
0
, P
i
or P
0
, C
i
or C
0
and L
i
or L
0
).
DANGER
!
WARNING
!
Crush hazard arising from actuator and
plug stem moving.
Î Do not touch any moving valve parts
while the control valve is in operation.
Î Before performing any mounting or in-
stallation work on the positioner, put the
control valve out of operation by discon-
necting and locking the supply air and
control signal.
Î Do not impede the movement of the actu-
ator and plug stem by inserting objects
into the yoke.
Î
The positioner was checked by SAMSON
before it left the factory.
− The product warranty becomes void if
service or repair work not described in
these instructions is performed without
prior agreement by SAMSON's Af-
ter-sales Service.
− Only use original spare parts by
SAMSON, which comply with the
originalspecications.
The positioner does not require any mainte-
nance.
Î Observe the maintenance instructions of
any upstream supply air pressure reduc-
ing stations.
WARNING
!

Table of Contents

Other manuals for Samson 3767

Related product manuals