Samsung AVXTJH028EE - Page 116

Troubleshooting
Samsung Electronics 4-25
■ LED lamp display with error detection(Remote Control Receiver) (cont.)
: On : Flickering : Off
- When stopping the operation during an error is displayed, all lamps are off.
- When restarting after stopping an operation, redisplay the error status by deciding the error again on Normal Operation.
- Refer to the “4. Troubleshooting” for detail contents related to the error mode.
Follow-up measuresCausesError type
Self diagnosis error display
(Include the indoor unit that is not
detected)
11. EEV close status defect
12. EEV open status defect
13. EVAP OUT sensor breakaway
14. EVAP IN sensor breakaway
15. COND MID sensor breakaway
16. Refrigerant complete leakage 2
nd
detection
17. COND high temperature 2
nd
detection
18. DISCHARGE high temperature 2
nd
detection
19. Low pressure switch 2
nd
detection
COMP DOWN
10. Reverse phase detection error
11. Freezing 6
th
detection compressor
stop
12. Compression sensor self diagnosis
(G8, G9)
13. Compressor down error by
compression ratio control
Plot switch detection
Peripheral control device option setting
error
EEPROM error
EEPROM option error
Outdoor Unit Operational
error
Overflow of condensed
water of indoor unit drain
plate
Setting error of the indoor
unit option device
Incorrectly input the indoor
unit option code
Not input the indoor unit
option code
Check error on the Outdoor
Unit display window then
take appropriate steps.
t$IFDLUIFESBJOQJQF
pump
t$IFDLUIFESBJOQJQF
clogging
Readjust the indoor PCB
option S/W
Input the indoor unit option
code
Input the indoor unit option
code
LED lamp display
Green Red
(Standard type)
(Reclama-
tion type)
$9;&6+B$BaLQGG 