7.8 <
Scanning>
Scanning and sending to SMB/FTP server
1 Press Scan to Server.
Note
If the authentication message shows, enter User Name
and Password. This message shows only when the network
administrator has set the authentication in SyncThru™
Web Service. (Page 13.9)
2 Pl
ace the originals face up in the DADF. Or you can use the scanner
glass for one sheet of paper.
3 A
djust the document settings in the Options tab.
4 S
elect Duplex and Resolution in the Options tab.
5 Pr
ess Scan to Server to show the SMB server list you entered in
the SyncThru™ Web Service. .
6 S
elect the destination SMB server.
Note
You can select up to five destinations using both of SMB or
FTP servers.
7 Press Start on the control panel.
The machine begins scanning and then sends the scanned image to
the
specified server.
Changing the scan feature settings
This part explains how to adjust the document settings for each scan job,
such as resolution, duplex, original size, type, color mode, darkness, and
more. The options you change will be maintained for a certain time, but
after that period, the options will be reset to default values.
Duplex
This feature especially applies when the original documents to be
scanned are two-sided. You can select whether the machine scans only
one side of the paper or both sides of the paper.
Press Scan to Server > the Basic tab > Duplex.
Or, Press Scan to Email > the Options tab > Duplex. Use left/right
arrows to toggle the values.
• 1 Sided: For originals that are printed on one side only.
• 2 Sided: For originals that are printed on both sides.
• 2 Sided, Rotate Side 2: For originals that are printed on both
sides. But the back is rotated 180 degrees.
Note
To use 2 Sided and 2 Sided, Rotate Side 2, you have to load
the originals on the DADF. Because, if the machine can not
detect the original on DADF, automatically changes the option to
1 Sided.
Resolution
You can adjust document resolution.
Press Scan to Server > the Basic tab > Resolution.
Or, Press Scan to Email > the Options tab > Resolution.
Use left/right arrows to toggle the values. The higher value you select the
clear result you get. But the scanning time may take longer.
Commonly, 100 dpi , 200 dpi and 300 dpi resolution are available only
when Color Mode is set to Color or Gray. The following table shows
detailed information feature, resolution and file format options.
Feature Resolution (dpi) File Format
Scan to Email 100, 200, 300, 600(B/W)
100,200,300
(Gray,Color)
PDF, Single-Page
TIFF, Multi-Page TIFF,
JPEG
Scan to PC 75, 150, 200, 300, 600, PDF, Single-Page
TIFF, Multi-Page TIFF,
JPEG
To Next Page
Loading...
