EasyManua.ls Logo

Samsung CLX-8540ND - Page 199

Samsung CLX-8540ND
403 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
Service Manual
4-37
Samsung Electronics
Code
NVM Description
(GUI)
Default
Max
/ Min
Function Description
109-090 Cardstock Temperature
offset
7 14/0 * Fusing temperature variableness of Cardstock type paper
* Default temperature : 150 ℃
* Range of variableness : 157 ~ 143℃ (150℃ +/- 7℃)
* In case, the value is more than 7 :
The fuser temperature increases (input value-7)℃ than 150℃
* In case, the value is less than 7 :
The fuser temperature decreases (7-input value)℃ than 150℃
109-100 Envelopes Temperature
offset
7 14/0 * Fusing temperature variableness of Envelope type paper
* Range of variableness : 157 ~ 143℃ (150℃ +/- 7℃)
* In case, the value is more than 7 :
The fuser temperature increases (input value-7)℃ than 150℃
* In case, the value is less than 7 :
The fuser temperature decreases (7-input value)℃ than 150℃
109-110 Labels Temperature
offset
7 14/0 * Fusing temperature variableness of Label type paper
* Default temperature : 150℃
* Range of variableness : 157 ~ 143℃ (150℃ +/- 7℃)
* In case, the value is more than 7 :
The fuser temperature increases (input value-7)℃ than 150℃
* In case, the value is less than 7 :
The fuser temperature decreases (7-input value)℃ than 150℃
109-120 Fuser Bias Duty 154 194/154 * Fuser Bias PWM
* Read only
* You can't chage this value. ( HH condition : 194 / Other : 154 )
109-130 Thick Temperature
Offset
7 14/0 * Fusing temperature variableness of Label type paper
* Default temperature : 150℃
* Range of variableness : 157 ~ 143℃ (150℃ +/- 7℃)
* In case, the value is more than 7 :
The fuser temperature increases (input value-7)℃ than 150℃
* In case, the value is less than 7 :
The fuser temperature decreases (7-input value)℃ than 150℃
110-000 LD Power Yellow(Half) 88 250/10 * This PWM sets the laser intensity to be shoot on OPC.
(This value is used at half speed that the process speed of OPC
is the half of normal condition )
* Default 88 PWM is approximately 0.223mW.
* This value changes +0.0026mw per +1 PWM.
* This value is to check the normal state of HVPS,LSU.
* The value set on EDC manually is not applied to the real printing.
* At real printing, the value is applied by the Look-Up Table
considering the environment and life automatically.
110-010 LD Power Magenta(Half) 88 250 /10
110-020 LD Power Cyan(Half) 88 250 /10
110-030 LD Power Black(Half) 88 250 /10

Table of Contents

Related product manuals