4-78
Troubleshooting
● Troubleshooting method :
4. Check the following.
-. Check if the Feed Sensor is assembled properly.
-. Check if the harness of the Feed Sensor is
connected properly.
-. Enter the EDC mode. Execute the Feed Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF
Test Routine Î 102-290 Î Start Î Status check Î
Stop)
PICKUP
ROLLER
FORWARD
ROLLER
RETARD
ROLLER
3. Check if the pick up roller rubber is worn out or
contaminated.
5. Check if the Harness is defective.
Check if the connector is connected properly.
To Next Page
Loading...
