4-83
Troubleshooting
● Possible Cause:
1. Feed sensor or Regi Sensor is defective.
2. Exit sensor is defective.
3. Feed Clutch is defective.
4. Regi Clutch is defective.
● Error message : Paper jam inside of machine
● Troubleshooting method :
● Symptom : Paper jam inside of machine
1. At Warm-up, the paper is jamming at Regi sensor or Feed sensor.
2. At printing, the paper is detecting at Regi sensor or Feed sensor continually.
3. At printing, the paper is not detected at exit sensor within a regular time.
● Code : 01-009
2. Insert the paper as shown right and check the Regi
Sensor.
(EDC Mode Î Test Routines Î Copier Engine/DADF
Test Routine Î 102-360 Î Start Î Check Status Î
Stop)
3. Check if the Exit Sensor is working properly.
(EDC Mode Î Test Routines Î Copier Engine/DADF
Test Routine Î 102-370 Î Start Î Check Status Î
Stop)
1. Check the following.
-. Check if the Feed Sensor is assembled properly.
-. Check if the Feed Sensor harness is connected properly.
-. Enter the EDC mode. Execute the Feed Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF Test
Routine Î 102-290 Î Start Î Check Status Î Stop)
To be continued on next page…
To Next Page
Loading...
