Samsung CLX-8540ND - Page 246

4-84
Troubleshooting
● Troubleshooting method :
6. Check if the Harness is defective.
Check if the connector is connected properly.
5. Check the following.
-. Check if the Feed/Regi Clutch are assembled properly.
-. Check if the Feed/Regi Clutch Harness are connected
properly.
-. Enter the EDC mode. Execute the Feed Clutch test.
(EDC Mode Î Test Routines Î Copier Engine/DADF Test
Routine Î 101-080 Î Start Î Operation Check (from
sound) Î Stop)
-. Enter the EDC mode. Execute the Regi Clutch test.
(EDC Mode Î Test Routines Î Copier Engine/DADF Test
Routine Î 101-050 Î Start Î Operation Check (from
sound) Î Stop)
Feed Clutch
Regi Clutch
4. Check if the Harness is defective.
Check if the connector is connected properly.
Regi Sensor
Exit Sensor
Regi Sensor
Feed Sensor