4-85
Troubleshooting
● Possible Cause:
- If there is no jammed paper but error has occurred at warm-up, exit sensor is defective.
● Error message : Paper jam in exit area
● Troubleshooting method :
● Symptom : Paper jam in exit area
● Code : 01-010
2. Check if the Harness is defective.
Check if the connector is connected properly.
1. Execute the Exit Sensor test.
(EDC Mode Î Test Routines Î Copier
Engine/DADF Test Routine Î 102-370 Î Start Î
Check Status Î Stop)
Exit Sensor
To Next Page
Loading...
