4-87
Troubleshooting
● Possible Cause:
1. Check the Duplex Sensor Harness and Connector.
2. Check if the UI message is changed by the Duplex Sensor operation.
3. Check the duplex sensor.
● Error message : Paper jam at the top of duplex path
● Troubleshooting method :
.
● Symptom :
1. At Warm-up, Duplex sensor has detected the paper.
2. At Printing, Duplex sensor is not on within a regular time after paper moves into duplex path.
● Code : 01-015
2. Check the following.
-. Check if the Duplex Sensor is assembled properly.
-. Check if the Duplex Sensor Harness is connected properly.
-. Enter the EDC mode. Execute the Duplex Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF Test Routine Î 102-380 Î Start Î Operation
Check Î Stop)
1. Check if the Harness is defective.
Check if the connector is connected properly.
To Next Page
Loading...
