4-88
Troubleshooting
● Possible Cause:
1. Check the Out-Bin Full Sensor Harness and Connector.
2. Check if the UI message is changed by the Out-Bin Full Sensor operation.
3. Check the Out-Bin Full Sensor.
● Error message : Too much paper in output bin tray. Remove printed paper
● Troubleshooting method :
● Symptom :
The out-bin full sensor is on for 600ms.
● Code : 01-017
2. Check the following.
-. Check if the Out-Bin Full Sensor is assembled properly.
-. Check if the Out-Bin Full Sensor Harness is connected properly.
-. Enter the EDC Mode. Execute the Out-Bin Full Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF Test Routine Î 101-190 Î Start Î Operation
Check Î Stop)
1. Check if the Harness is defective.
Check if the connector is connected properly.
To Next Page
Loading...
