4-98
Troubleshooting
● Code : 03-010 ● Error message : Motor does not operate: #03-010. Please turn off then on.
● Symptom : The motor to engage/ disengage the transfer belt does not operate.
● Possible Cause:
1. Harness is defective, Connector is not connected properly.
2. T1 Engage DC Motor is defective.
3. Engine Board is defective.
● Troubleshooting method :
T1 Engage DC
Motor
‘BLDC OPC‘
(CN24, 12pin)
‘T1 Engage sensor‘
(CN35, 3pin)
1. Check the following.
-. Check if the Engine Board Harness is defective.
-. Check if the harness is connected to the ‘BLDC OPC’ Connector on Engine Board properly.
-. Check if the harness is connected to the ‘T1 Engage sensor’ connector properly.
2. If the connection is no problem, enter the EDC mode and execute the T1 Engage Motor test.
If the T1 Engage motor does not operate, replace it.
[ How to replace the DC motor ]
① Remove the SMPS board shield.
② Remove 2 screws and unplug the connector. Replace the T1 engage DC motor.
3. If the problem persists after replacing the T1 Engage DC Motor, replace the Engine Board.
To Next Page
Loading...
