4-148
Troubleshooting
● Possible Cause:
1. Tray1 Paper Low Sensor harness is not connected properly.
2. Tray1 Paper Low Sensor is defective.
● Error message : Paper is low in tray 1. Load paper
● Troubleshooting method :
● Symptom :
There are enough papers in tray1 but error message is displayed.
● Code : 21-004
2. Check the following.
-. Check if the Tray1 Paper Low Sensor is assembled properly.
-. Check if the Tray1 Paper Low Sensor harness is connected properly.
-. Enter the EDC mode. Execute the Tray1 Paper Low Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF Test Routine Î 102-060Î Start Î Operation
check Î Stop)
1. Check if the Harness is defective.
Check if the connector is connected properly.
To Next Page
Loading...
