100
• Tap to take pics
: Allows you to tap the screen to take a picture.
•Save as
: Assigns rich tone usage to an image (available in
HDR mode only).
•Video size
: Select a resolution for photos. Use higher resolution
for higher quality. Higher resolution photos take up more
memory.
• Recording mode
: Choose whether to limit video size for
multimedia text messages. Select either Normal or Limit for MMS.
• Effects
: Select an effect to apply to pictures or videos that will be
taken.
•Flash
: Set the flash to On (always flash), Off, or Auto (flash only
if the light levels require it).
•Timer
: Use this for delayed shots. You can set the timer to Off,
2 sec, 5 sec, or 10 sec.
•Location tags
: Attaches a GPS location tag to the photo. To
improve GPS signals, avoid recording in locations where the
signal may be obstructed, such as between buildings or in
low-lying areas, or in poor weather conditions. Your location
may appear on your photos when you upload them to the
Internet. To avoid this, deactivate the location tag setting.
•Storage location
: Select storage location if a memory card is
installed. You can choose between device storage and memory
card.
• Review pics/videos
: View each photo or video immediately
after you take it.
• Remote viewfinder
: Take pictures using the viewfinder of a
connected device. A Wi-Fi Direct connection is required.
• The Volume key
: Assign a function to the volume key. Choose
from Take pictures, Record video, or Zoom.
• Voice control
: Set the camera to take photos with voice
commands.
•Help
: Display Camera information.
• Reset settings
: Reset the camera settings.
Viewing Your Photos
After you take a photo, you can access various options from
the Image Viewer. The Image Viewer uses your Gallery. For
more information, refer to “Gallery” on page 102.
To Next Page
Loading...
