96 Section 2G. Voice Services
To adapt the system for voice:
1. Highlight and press > Settings/Tools >
Tools > Voice Service.
2. Press Settings (right softkey) > Adaptation > Adapt
Voice.
3. Press Start (left softkey), wait for the beep, and then
repeat the words, commands and digits using a
normal tone of voice.
䡲 If the recording is not acceptable, the phone will
prompt you to repeat the phrase.
4. When you are finished with a full session, you will
reach a screen that reads “Adapting...”
To reset the adaptation:
1. Highlight and press > Settings/Tools >
Tools > Voice Service.
2. Press Settings (right softkey) > Adaptation > Reset
Voice > Yes (left softkey).
To change the ASR mode:
1. Highlight and press > Settings/Tools >
Tools > Voice Service.
2. Press Settings (right softkey) > Audio Modes and
select an option:
䡲 Expert Mode to sound a beep only.
䡲 Prompt Mode to prompt for required information.
Note
It is recommended that you perform the complete
adaptation of Digit Dial at least once to achieve the
maximum benefit of this feature. If a partial
adaptation is performed, you should repeat the
process from the beginning.
Note
Reset Voice is available only after the phone has
undergone an adaptation session.
Boost M540.book Page 96 Wednesday, March 24, 2010 4:48 PM
To Next Page
Loading...
