110 Section 2I. Camera
䡲 White Balance to adjust white balance based on
changing conditions (
Auto, Sunny, Cloudy, Tungsten,
Fluorescent, or Manual). (The default setting is Auto.)
䡲 Night Shot to activate low light image capture.
Enabling this feature allows you to take better
quality photos in low light conditions.
䡲 Metering to allow the phone to sample the area
being photographed and then determine the best
light levels. Choose from either
Spot (a specific
area of the image) or
Average (the entire image is
sampled and then an average reading is used).
䢇 Settings.. to select Resolution, Quality, Shutter Sound,
Status Bar or Storage. (See Camera Mode Options for
details.)
䢇 Launch to Review Pictures or launch the Camcorder.
Setting the Selftimer
1. From camera mode, press Options (right softkey) >
Selftimer.
2. Highlight the length of delay you want the timer to
use (
5 sec or 10 sec) and press .
(The default setting is
Off.)
3. Press when you are ready to start the timer.
(The timer displays on the middle-right portion of
the display screen during the self-timer
countdown).
4. Get ready for the picture. (The phone will beep for
each second of the countdown, and the outer LED
will blink green. When the timer is down to three
seconds, the outer LED will blink red. Just before
the picture is taken, the LED turns solid red.)
To cancel the selftimer after it has started:
䊳 Press or .
Taking Multiple Shots
This feature allows you to take a series of shots in a
continuous sequence.
To shoot a series of individual pictures:
1. From camera mode, press Options (right softkey) >
Multi Shot > Series Shot.
2. Select one of the following options and press :
䡲 Off to deactivate the multiple shots option.
Note
While the sefltimer is active, all keys are disabled
except
and .
Boost M540.book Page 110 Wednesday, March 24, 2010 4:48 PM
To Next Page
Loading...
