25
2. Product function
To select this function, open the refrigerator door and press the button on the control panel of
CoolSelect Zone
TM
drawer.
When the CoolSelect Zone
TM
function is selected, the damper inside fan ductwork is open. So
the refrigerator cooling is performed first, then the damper is closed to control the CoolSelect
Zone
TM
temperature.
1) Select function
1-1) Using Select button, Cool, Chill(30 (-1 )), and Soft Freeze(23 (-5 )) options can be℉ ℃ ℉ ℃
selected in sequence. Cool option maintains a set temperature of the refrigerator.
2) Quick Cool function
2-1) If the Quick Cool is selected, LEDs will flash 60 and Min. The count will be decreased in
every minute.
2-2) To cancel this function, press Quick Cool button again or Thaw button or Select button.
Otherwise, it will be terminated 60 minutes later automatically.
2-3) After this function ends, this drawer will come back to Cool option.
2-4) A defrost cycle will be postponed until Quick Cool option is finished.
3) Thaw function
3-1)When the thaw button is pressed, LEDs will flash 4, 6, 10, and 12 in sequence and Hr.
3-2) The count will be decreased in every hour.
3-3) A cancellation of this function is the same as Quick Cool function.
3-4) After this function ends, this drawer will be maintained with 30 (-1 ).℉ ℃
3-5) While the compressor is on, this drawer retains a certain temperature and while the
compressor is off, the defrost heater is activated and Refrigerator Fan is on with a closed
position of the damper.
2-4. COOLSELECT ZONE FUNCTION
To Next Page
Loading...
Need help?
General
