42
3. Full disassembly and assembly
2. Disconnect the ice
maker wire
connector.
3. Unlock the locking
tabs to separate the
ice maker kit.
1. Remove the screws.
ICE MAKER
KIT
This shelf is designed to support the ice maker & ice
dispensed and Xtra Space TM.
1. Remove the Xtra Space TM cover to push it down and pull front.
2. Slide the partition out.
3. Remove the screws (2) on the bottom front of the case.
4. Slide out the case while disconnecting the wire connect.
AUGER
MOTOR
CASE
The ice dispenser is located in the upper portion of the freezer.
This assembly stores ice made by the icemaker and dispenses ice.
1. Lift the ice bucket up and slide out the ice dispenser assembly .① ②
ICE
DISPENSER
& ICE
MAKER
RemarksWork orderPart name
Partition
If you want to reassemble, follow the reverse order
Screw
When disassembling, make sure the unit turned off
To Next Page
Loading...
Need help?
General
