40
3. Full disassembly and assembly
Part name Work order Remarks
EVAPORATOR IN
REFRIGERATOR
Evaporator is located in the bottom of
refrigerator.
1. Take off the ductwork in refrigerator.
2. Disconnect the wire connector. (Heater and
Thermistor)
3. Desolder the capillary tube and the suction
line from the evaporator.
4. Remove the evaporator.
5. With a file, score the capillary tube just
upstream of the soldered point. Break off the
soldered section to help prevent solder from
plugging the tube during soldering.
6. Place a new evaporator and braze the suction
and capillary tube to evaporator using silver
solder.
7. Install a replacement dryer.
8. Evacuate and recharge the system using
reasonable procedures.
If you want to reassemble, follow the reverse order
When disassembling, make sure the unit turned off