30
2. Product function
2-6. Ice-Maker Function
5) Ice production
3-1) After 60 minutes pass from the water supply, the control board will check the temperature.
3-2) If the sensor reads the temperature lower than 1 (-17 ) for more than 5 minutes, ℉ ℃
than the ice production process is completed.
6) Test function
● In order to operate a test function, press the knob (Test Switch) for 1.5 second.
● This function can be used to check a proper working, to clean the ice tray, and to adjust the
water level in the ice tray.
4-1) This function only works when the ice tray is leveled and the ice full signal is cleared.
4-2) When the water line is connected, each process such as a water supply, ejection, and
leveling, can be investigated by this button.
7) Ice off function
5-1) When the Ice off option is selected by Ice Type button, the ice making process will cease.
5-2) When the ice making process ceases, the final state will be the ice tray with supplied water.
5-3) When Cubed or Crushed option is selected again, the control board will check an
accumulated time period. After making it 60 minutes and when the ice tray temperature is
acceptable, ice ejection process will begin.
8) Functions when the freezer door is open
● When the freeze door is open, all ice maker related processes will cease in order to minimize
noise and to prevent ice from dispensing.
6-1) The ice tray stops moving regardless of the position.
6-2) The water supply process remains working as usual.
6-3) If the ice tray is in the middle of ice ejecting process, close the freezer for 30 seconds and
check if the tray is leveled. If it is not leveled, it must be out of order.
To Next Page
Loading...
Need help?
General
