English _53
● LIVE
EVENT MONITORING
This will display the channel in sync with a specific event (Sensor/Motion/Video Loss) if it occurs.
In "Monitor > Event Display", set the event monitoring to ON/OFF and specify the event display time. (Page 85)
• If multiple events occur simultaneously, the screen will switch to a split mode.
- 2~4 events : 4-split mode
- 5~9 events : 9-split mode
- 10~16 events : 16-split mode
• If the second event occurs within the set time of <Event Display>, the first event will last until the second one
is terminated.
` Ex : If you set <Event Display> to 5 seconds, and only one event occurs in CH 1.
` Ex : If you set <Event Display> to 5 seconds, and the second event occurs in CH 2 within the set time after the first event
occurred in CH 1.
M
` Press the [ALARM] button or select <Stop Alarm> to initialize the alarm output status and cancel the event function.
` If an alarm is output with the pre-event and post-event times specified together with the event recording settings, the event
recording will perform according to the specified recording type (pre event or post event).
J
` In case of continuous events such as motion detection, switching to another split mode display may not immediate if
concatenating events follow, even when you stopped alarm of the event.
` The video may be delayed depending on the network condition.
` The event output can be delayed as the transfer of the alarm event from the network camera takes time.
To Next Page
Loading...
