English _83
● MENU SETUP
Storage Device
You can check information on storage devices.
Device/Format
You can check storage devices and their capacity, usage as well as status.
Devices available are HDD, and USB devices (Memory, HDD).
[MENU] [ENTER] ▼ <Menu> [ENTER] ▼ <Device> ►▼ <Storage Device>
[ENTER] ▼ <Device/Format> ▲▼◄► [ENTER]
• Storage Status : Displays the working status of a storage device.
-
Red : Displays the situation of video loss.
-
Green : Displays the normal situation without video recording losses.
-
Status
` Full BPS : Displays the current rate of recording.
` Current Loss Rate : Displays the current recording loss rate.
` Max Loss Amount : Displays the maximum amount of losses up until now.
• No. : You can check the designated number for the built-in HDD.
` If you want the find out about the location corresponding to the HDD number, refer to the <HDD Map>.
• Capacity : Displays the amount of storage device use and the full capacity.
• Usage : Designate the purpose of use for a storage device.
• Status : Displays the current working condition of a storage device.
For inspection or replacement of HDD alarms, please refer to "HDD Alarm Setting." (Page 84)
-
Normal : It is displayed during normal operation.
-
Inspection : Operating with partial problems.
-
Replacement : It is displayed when you can no longer use it.
• Temperature : You can check the temperature of the HDD mounted in the NVR.
To Next Page
Loading...
