English _19
● INSTALLATION
5. When the installation of additional HDDs is done,
insert the lower and upper brackets into the NVR and
fix them with the provided screws.
6. When adding a HDD is completed, plug the power
cable and connect the SATA cable (for transferring
the HDD signal) to the connector
~ of the
main board.
` Note that the order the HDD data cable is connected will not
affect the operation. The only consideration is the length of
each cable.
7. Check if the connectors are properly connected and
there is no problem with wiring, and close the cover
and fix it with screws.
NETWORK VIDEO RECORDER SRN-1670D
Cover
To Next Page
Loading...
