English _91
● STARTING WEB VIEWER
CONNECTING WEB VIEWER
1. Open your web browser and type the IP address or URL of
NVR into the URL address box.
M
` “192.168.1.200” is set to IP by default.
` You must have specified the IP address in “Network > Connection
Mode”.
` The URL connection will be enabled only when the DDNS connection settings have been completed.
For more information, refer to “Network Configuration > DDNS”. (Page 78)
2. A user with the admin permissions should provide the admin
ID and password. A registered user should provide the user
ID and password.
J
` The initial administrator ID is “admin” and the password should be
set when logging in for the first time. (Initial password of the Admin
user is set to “4321”.)
` Set password for your wireless network if you use the product with a wireless router. Being not protected with password or
using the default wireless router password may expose your video data to potential threat.
` Please change your password every three months to safely protect personal information and to prevent the damage of the
information theft.
Please, take note that it’s a user’s responsibility for the security and any other problems caused by mismanaging a password.
M
` It allow s up to 10 simultaneous access including the Admin and general users.
` It does not allow multiple login of the Admin user.
` Password of the Admin and general users can be changed in <Permission Management> menu of the NVR.
` Normal users should have set <Webviewer> under <Restriction on Network Access> to Use before connecting to the
Web Viewer. (Page 48)
` All settings are applied by the NVR’s settings.
3. Click <Install ActiveX Control...>.
4. When the installation confirm message appear, click [Yes]
button.
To Next Page
Loading...
