SETTING THE DEVICE
You can setup Camera, Storage Device, Remote Device and Monitor.
Camera
To register a camera
You can register a network camera for each channel and make connection between.
[MENU]
▲▼
<Device>
►
<Camera> [ENTER]
▲▼◄►
[ENTER]
•
Protocol : Show the protocol information of a registered network camera.
•
Model : Show the camera model name.
•
IP : Display the IP address of a network camera.
•
Connection : Display the connection status.
•
Register : This is the default registration button for a network camera.
It will be displayed <Auto> before registration, and will be changed to <Delete> after registration.
M
` If the NVR has been initialized, it may not connect to cameras. Configure the network settings first and add cameras.
For more information on network settings, refer to “Network Configuration”. (Page 74)
To auto-search for and register a network camera
1. Select <Auto> in the <Register> item and press [ENTER].
2. The "Add Camera Automatically" window appears and NVR starts searching for connected network
cameras.
` An already registered camera will be marked in blue in the list.
To Next Page
Loading...
