Optical Tunable Filter OTF-930
6-1
Safety Information
6
6.1. Mains Voltage
See Section 10.4 for details of changing the fuse. Ensure that the rating of the fuse corresponds to
the mains voltage selected; details are given in Section 10.4.
The unit is provided with a three pin cord. To ensure the safe operation of the instrument please
make sure that this is connected to a grounded power outlet.
6.2. Installation
To ensure the safe operation of the instrument it should not be installed:
•
In a position where the air from the cooling fan cannot ow freely. Allow at least 5cm behind
the unit for this purpose.
•
Where there are high levels of vibration.
•
Where it would come into contact with water.
•
In very humid or dusty locations.
•
Where there are strong electric or magnetic elds.
•
In direct sunlight.
•
Where there are extremes of temperature.
CAUTION
It is necessary to remove the power cord from the rear panel of the instrument to completely
isolate the instrument from the mains supply.
6-1. Mains Voltage
To Next Page
Loading...