Santec OTF-930 - Safe Operation

6-2
OTF-930 Operation Manual
6.3. Safe Operation
The unit should not be operated in any of the following circumstances:
• If water or other liquid is spilt on the unit.
• When the unit is cleaned or moved.
• If damage is found to the mains cord.
In the event that these occur while the unit is being used the Power On / Off Key Switch should
be turned off immediately, and the mains power turned off at the outlet.
Also, please note that if the unit is moved from a cool location to a warm location there is a
possibility that condensation may form on the inside of the instrument. In these circumstances
allow sufcient time for the instrument to dry thoroughly before connecting the mains power.
DANGER!!
There is a danger of serious injury or death from electric shock if the instrument is
used without the correct connection to ground. A three pin cable is supplied with the
Please note the following points when utilizing the instrument in order to protect and prevent
instrument failure.
DANGER!!
As for this product, when the lase is input from OPT.IN, the laser is output from OPT.
OUT. The laser beam may cause permanent damage to your sense of sightif it comes
in contact with your eyes. Therefore special attention and careful manupulation must
be taken when operate this instrument. When the unit is not used, be sure to close the
protective shutter (shown in the gure below).
Protective shutter
Laser beam emitting port