Santec TSL-550 - 7-4-1. Command set 1 (Complies with IEEE-488.2)

Tunable Semiconductor Laser TSL- 550
7-23
4. TSL-550 Specic command overview
An overview of the specic commands available in Command set 1 is shown in
the following table.
TSL-550 Specic Command List (Command set 1 Group)
Command Description Page
:SPECial:REBoot Resets the device.
7-26
:SYSTem:ERRor? Reads out the error issued. 7- 26
:SYSTem:VERSion? Reads out the version of the rmware. 7- 26
:SYSTem:COMMunicate:GPIB:ADDRess Sets the GPIB address. 7- 26
:SYSTem:COMMunicate:GPIB:ADDRess? Reads out the GPIB address. 7- 26
:SYSTem:COMMunicate:GPIB:DELimiter
Sets the command delimiter for GPIB
communication.
7- 27
:SYSTem:COMMunicate:GPIB:DELimiter?
Reads out the command delimiter for GPIB
communication.
7- 27
:SYSTem:COMMunicate:SERial:SPEed Sets the speed of serial communication. 7- 27
:SYSTem:COMMunicate:SERial:SPEed? Reads out the speed of serial communication. 7- 28
:SYSTem: COMMunicate:SERial:DELimiter
Sets the command delimiter for serial
communication.
7-2
8
:SYSTem:COMMunicate:SERial:DELimiter?
Reads out the command delimiter for serial
communication
7-2
8
:SYSTem:Lock? Check for Interlock and system lock (option) 7-29
:TRIGger:INPut:EXTernal
Sets Enable/Disable of the external trigger
signal input.
7-29
:TRIGger:INPut:EXTernal?
Reads out the setting of the external trigger
signal input.
7-29
:TRIGger:INPut:STANdby
Puts the device in trigger signal input standby
mode.
7-29
:TRIGger:INPut:STANdby?
Reads out the trigger signal input standby
mode.
7-30
:TRIGger:OUTPut Sets the timing of the trigger signal output. 7-30
:TRIGger:OUTPut?
Reads out the timing setting of the trigger
signal output.
7-30
:TRIGger:OUTPut:STEP[:WIDTh] Sets the interval of the trigger signal output. 7-30
:TRIGger:OUTPut:STEP[:WIDTh]?
Reads out the interval of the trigger signal
output.
7-31
[:SOURce]:COHCtrl Turns ON/OFF the coherence control. 7-31
[:SOURce]:COHCtrl? Reads out the state of the coherence control. 7-31
[:SOURce]:POWer:STATe Sets ON/OFF the LD. 7-31
[:SOURce]:POWer:STATe? Reads out the ON/OFF status of the LD. 7-32
[:SOURce]:POWer:ATTenuation Sets the attenuator value. 7-32
[:SOURce]:POWer:ATTenuation? Reads out the attenuator value. 7-32
[:SOURce]:POWer:ATTenuation:AUTo Switches to Auto/Manual for the power control. 7-32
[:SOURce]:POWer:ATTenuation:AUTo? Reads out the setting of the power control. 7-33