- 51/250 -
Section 1 Maintenance
SCC1000C Crawler Crane — Maintenance Manual
Prole of Engine (Tier
Ⅲ
)
-- Check its status for any abnormality when starting up the engine,
-- Check the connecting bolts in the engine area visually each time before starting up the engine or every
day. As all the securing bolts are applied with bolt thread sealant, they normally will not loosen up and a
visual inspection would be sufcient. Remove the bolts that are loose, broken, or defective and replace
with new ones,
-- Operate the crane according to the operating instructions and load charts. Check the securing bolts
regularly as required, avoiding risks caused by bolt fatigue.
Engine air intake
pipe
Engine air intake
pipe
Sensor wire
harness
air-conditioner
compressor cold
water pipe
fuel lter
T103 7014
https://cranemanuals.com
To Next Page
Loading...
