SANY SCC1000C - Checking the Oil Level; Replacing Engine Oil

- 65/250 -
Section 1 Maintenance
SCC1000C Crawler Crane — Maintenance Manual
CAUTION
WARNING
4�6 Checking and Replacing Engine Oil
4�6�1 Checking the Oil Level
Check the engine oil level before commencing
work. Take out the dipstick and wipe it. Then
replace the dipstick and pull it back out of the hole.
If the oil level is within the scale marks, the oil level
is normal.
When checking the oil level, the crane must
be on level ground� Otherwise, the checking
result is not correct�
-- Do not open the oil drain screw plug
when the engine oil is hot to avoid risk
of scalding�
-- Any breach of this regulation may cause
serious personal injury and death�
4�6�2 Replacing Engine Oil
1. Use a piece of clean cloth to wipe surface
around the engine oil lling hole and remove the
cap.
2. Place a container(25L(6.6 gal) or larger) below
oil drain screw plug on the engine oil pan and
remove the oil drain screw plug to release
engine oil.
3. Properly remove the engine oil lter and discard
it. Use a piece of clean cloth to wipe surface
around base of the engine oil lter housing.
4. Apply a thin layer of engine oil on the O-ring of
the new engine oil lter and install it.
5. Tighten the lter manually till it reaches the lter
base and then screw continually by another 3/4
thread.
6. Install and tighten the oil drain screw plug.
7. Pursuant to specication and volume of oil used
for the engine recommended in this manual,
fill the proper level of engine oil meeting the
specications into the engine oil lling hole.
8. Install the cap of the engine oil lling hole.
9. Start the engine to check for leaks. Shut off the
engine and remove the key. After several
minutes, pull out the engine dipstick to check the
level of the engine oil.
https://cranemanuals.com