- 55/250 -
Section 1 Maintenance
SCC1000C Crawler Crane — Maintenance Manual
4.2.5 Relling the Fuel
Fill up the fuel tank after the completion of each day’s
work to reduce the formation of condensation. Fill fuel
into the tank with a pump.
No re near the fuel.
No smoking when refilling� Otherwise,
there is fire hazard which may lead to
property loss, personal injury and death�
The fuel filling pump cannot be left running
idle�
CAUTION
4.3.1 Cooling System Diagram
4�3 Cooling System
Burning and scalding hazard�
Ensure 60 minutes cooling before
implementing the described work�
DANGER
Cooling System
Fan
Belt roller
Water pump
intake
Radiator
1. Antifreeze is essential in every climate. Check
coolant level daily before starting the engine.
Refill coolant if the coolant level is below the
sight glass on expansion tank.
2. Only use the antifreeze designated by the
manufacturer. Use of inappropriate antifreeze
can cause damage (or corrosion) to the engine,
such as leaks in water pump. Do not add cold
coolant to a hot engine. Allow the engine to
cool to below 50°C before adding coolant of
the same specications. Otherwise the engine
casting will be damaged.
3. Check the radiator and fan regularly. Be sure
that the radiator is not blocked by leaves, dust
or other debris. Clean the radiator, as required.
4. A visual inspection of the drive belts (fan,
alternator, etc.) is required daily. Check for
wear and cracks before starting the engine.
Transverse cracks are acceptable. Replace the
belt if any longitudinal crack is found.
5. Only use the coolant filter approved by the
engine manufacturer. Replace the lter element
regularly. The antifreeze must be added with
an appropriate amount of DCA4 to prevent air
corrosion to the cylinder liner or corrosion to the
cooling system.
T103 7008
DANGER
https://cranemanuals.com
To Next Page
Loading...
