Up to 99,999 hours can be set for the time setting.
If condition "When Auto Play is failed" is checked, the trap is sent when the error occurs during the auto dis-
play operation using with the network viewer function (p.109). For further information of the error, refer to
item "Auto Display setting and control page [3]"((p.123).
Trap option
Trap option setting
Tick the check boxes in front of the condition item to send the trap.
Click Set button if you tick or un-tick the check box on a page.
[1]––––––––––––––––––––––––––––––––––
O
When PJ lamp is off.
O When PJ lamp replacement time is reached.
O When internal PJ power circuit is failed.
O When internal PJ temperature is too high.
[2]––––––––––––––––––––––––––––––––––
O When PJ is turned into Standby in proper user
operation.
O When lamp Corres. Value reaches
[ ] hours.
O When Power management function turns PJ
lamp off.
[3]––––––––––––––––––––––––––––––––––
O
When the signal is interrupted.
O When Auto Play is failed.
O When accumulated filter use time
reaches [ ] hours.
SNMP setting
To Next Page
Loading...
