Check & Change page in the light mode
Following functions in the "Check & Change" page are not avail-
able in the light mode.
- Changing the control mode.
- Deleting the registered IP address
- Indicating the each status
- Indicating the each memo
Controlling all together
"Power & Status", "PC adjustment", "Control" and "Setting" can be
controlled all together. Set "ON" the multi control setting and ad-
just controls of each menu. The setting value is applied to the reg-
istered projectors sequentially .
This is effective only if the multi control item of the registered pro-
jector i set to either "Both control" or "Control".
Setting all together
"E-mail setting", "SNMP setting" and "Timer" can be set all together.
Set "ON" the multi control setting and items of each menu. The set-
ting value is applied to the registered projectors sequentially.
This is effective only if the multi control item of the registered pro-
jector is set to either "Both control" or "Control".
(Check & Change page in the light mode)
This indicates that the
mode is "VisualControl".
This indicates that the
mode is "Control".
Connection status
Blinking: Connected
Gray: Disconnected
Multi-control
To Next Page
Loading...
