26
Basic Operation
NO SHOW button
Press the P-TIMER button on the remote control to operate
the Count up/Count down function. Refer to p.51 for detail of
Setting for the P-timer function.
To stop the count time, press the P-TIMER button.
To cancel the P-timer function, press and hold the P-TIMER
button.
P-TIMER button
Press the IMAGE button on the remote control to select a
desired image mode of the screen. See pages 32, 39 for
details.
IMAGE button
No show disappears after 4 seconds.
P-Timer display
✔Note:
See the previous page for the description of
other buttons.
IMAGE button
NO SHOW button
P-TIMER button
SCREEN button
Select the screen size (See pages 34-35, 42 for details).
SCREEN button
• • • • •
Press the NO SHOW button on the remote control to black out
the image. To restore to normal, press the NO SHOW button
again or press any other button. When the projected image is
captured and is set as User in the Logo selection (p.47), the
screen changes each time you press the NO SHOW button as
follows.
✔Note:
When use the MUTE button to release the No Show
function, the mute function can not be operated at the same
time.
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General