27
Choose either Computer 1(RGB) or Computer 2(RGB) by pressing the COMPUTER 1 or COMPUTER 2 button
on the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
3
Computer Input
COMPUTER 1 button
✔Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.44).
Computer
1
Remote Control
Press the MENU button to display the On-Screen
Menu. Use the Point buttons to select Input and
then press the Point or the SELECT button.
Use the Point buttons to select Computer 1.
When Computer 1 is selected, press the Point
button to access the submenu items. Use the Point
buttons to select the RGB input source and then
press the SELECT button.
Computer 1(RGB)
Computer 1(Scart)
Computer 1
RGB
Component
RGB(Scart)
S-video
►
Input Source Selection (RGB: Computer 1/Computer 2)
Computer 2 (RGB)
COMPUTER 2 button
Direct Operation
Menu Operation
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General