37
Video Input
Choose Computer 1(Component) or Computer 1(Scart) by pressing the COMPONENT or the COMPUTER 1
button on the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
Use the Point buttons to select Computer 1 and
then press the Point button.
Input Source Selection (Component, RGB Scart 21-pin)
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/S-VIDEO IN/COMPONENT IN terminal
with a Component-VGA Cable, select
Component.
Component
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/S-VIDEO IN/COMPONENT IN terminal
with a Scart-VGA Cable, select RGB
(Scart).
RGB (Scart)
Press the MENU button to display the On-Screen
Menu. Use the Point buttons to select Input and
then press the Point or the SELECT button.
✔Note:
When the Input Search function is set to On1 or On2,
the input signal will be searched automatically (p.44).
COMPUTER 1 button
Remote Control
3
Use the Point buttons to select Component or
RGB(Scart) and then press the SELECT button.
Computer 1(RGB)
Computer 1(Scart)
COMPONENT button
Computer 1(Component)
Direct Operation
Menu Operation
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General