-12-
This projector provides 2 types of standby mode, Eco standby and Network standby. According to the standby mode
"Eco" or "Network", several functions are restricted as shown in the table below. To change the standby mode, use
the projector's menu "Setting".
Network...... Supply the power to the network function even after turning off the projector. You can turn on/ off the
projector via network, modify network environment, and receive an e-mail about projector status while
the projector is powered off.
Eco............. Select “Eco” when you do not use the projector via network. The projector’s network function will stop
when turning off the projector.
When "Eco" is selected, several functions will be restricted.
Restricted Function in the standby mode
Standby Mode Notice
Function Eco Network
Serial command control
--
✔
Network Function
--
✔
Monitor Out
--
✔
Audio Out
-- --
Mic Out (MIC Volume)
--
✔*
Direct on
✔ ✔
* MIC volume can be output when the Standby MIC Out function is set to On.
To Next Page
Loading...
Need help?
General
