-15-
Note:
Do not replace the LCD panel
separately otherwise it can
not obtain proper picture.
Fig.4-1
1 Remove 4 hex screws A and take the LCD/Prism ass’y off upward.
2 Remove 3 screws B and take the Glass Holder, and then pull the
Polarized Glass-Out, Pre-polarized Glass-Out and Optical Filter(WV)
upward off. These glasses are mounted for R, G and B LCD panels
respectively. The R-panel does not provide the Pre-polarized Glass-Out.
Note:
To avoid the CG and focus alignments slipping off, please be careful to han-
dle the LCD/Prism ass'y.
LCD Panel/Prism Ass’y
Polarized Glass-Out and Optical Filter(WV) removal
A
A
A
Optical Pats Disassemblies
LCD Panel/Prism Assembly
LCD PANEL
(GREEN)
LCD PANEL
(BLUE)
LCD PANEL
(RED)
1245
2345
32 4 5
Phase Sheet
(*2)
TOP VIEW
Fig.4-3
*2 See Fig 4.3 below for the mount
direction of the parts.
Fig.4-2
B
B
B
Pre-Polarized
Glass-Out (* 1)
Phase Sheet
Optical Filter(WV)
Phase Sheet
Polarized Glass-
Out
Mount direction of the parts
Key No. Parts
1 Prism assembly
2 Polarized glass out
3 Pre-polarzed glass out
4 Optical Filter(WV)
5 LCD panel
To Next Page
Loading...
