Sanyo PLV-WF10 - Page 48

-48-
Unevenness color : N.G.
Unevenness color : Good
Unevenness color : Good
Unevenness color : N.G.
■ Integrator-lens-out adjustment
Before Adjustment :
1. Remove the flexible cables on LCD panels
from the assembly Main. And turn on the
projector.
2. If the shade appears on the left or right of the
screen, adjust the integrator lens out with the
following procedure.
Adjustment :
1. Loosen three screws-B.
2. Insert a slot screwdriver into slot-A, turn and
adjust it so that the shade may disappear or
reduce.
3. Tighten the three screws B to fix the integra-
tor lens out.
Shade
SCREW-B
SCREW-B
BOTTOM
SIDE
SCREW-B
SLOT-A
Integrator-lens-out unit
START
Change the lamp mode to “Lamp-1”.
(Refer to operation method-1 on page-49)
Check the condition of Unevenness color on
the screen.
Fine adjustment-1 Integrator lens out
(Refer to Fine adjustment-1 on page-49)
Fine adjustment-1 Integrator lens out
(Refer to Fine adjustment-1 on page-49)
END
Change the lamp mode to “Lamp-2”.
(Refer to operation method-1 on page-49)
Change the lamp mode to “Lamp-1”.
(Refer to operation method-1 on page-49)
Check the condition of Unevenness color on
the screen.
Change the lamp mode to “Lamp 1 and 2”.
(Full lamp mode)
(Refer to operation method-1 on page-49)