Sanyo PLV-WF10 - Optical Unit Removal

Remove 12 screws and then pull the
optical unit upward and remove.
Caution:
The following caution is the important mat-
ter for maintaining the safety of a product.
Don't mistake the attachment direction of the cooling fan in the
case of a re-assembly. (Refer to the arrow in a figure.) If the
attachment direction is mistaken, it will become the cause which
the inside of the projector is unusually overheated and a fire or
parts damage.
01. Remove 3 screws A and remove the assembly motor &
audio.
02. Remove 4 screws B and remove the power holder.
03. Remove 4 screws C and remove the power holder top.
04. Remove 6 screws D and remove the assembly sub power.
05. See caution before the Fan (FN902) removal.
06. Remove 4 screws E and remove the Fan (FN902).
07. Remove 2 screws F and remove the Fan (FN913).
08. Remove 2 screws G and remove the assembly PFC Fan-
net.
09. Pull the assembly power upward and remove.
10. Pull the assembly PFC upward and remove.
-11-
5.
Assembly Motor & audio, assembly Power, assem-
bly PFC, assembly Sub power, assembly PFC Fan-
net and Fan(FN902 and FN913) Removal.
6.
Optical unit removal.
B
B
A
A
A
B
B
C
C
C
C
D
D
D
D
D
D
E
E
E
E
Power holder
Power holder top
Ass'y Motor & audio
Ass'y Sub-power
Ass'y
PFC
Ass'y
power
FN902
The direction of a wind. *
G
G
F
F
Ass'y PFC FANNET
FN913
Optical unit